shock mount การใช้

• The SM58 uses an internal shock mount to reduce handling noise.
• The shock mounts have been known to tear free causing catastrophic collapse and damage.
• The shock mounts help protect the shipboard operating equipment from the shock of explosions.
• These washers, which have come to be called'shock mounts', allow the backrest to flex slightly.
• Hut Stricklin initiated the contact, breaking a shock mount.
• Naval ships have special shock mounts to minimize machinery noise being transmitted to the water.
• The shock mounts are glued to the wooden backrest, but may tear free for various reasons.
• The backrest was also attached using shock mounts.
• In a variety of applications, a "'shock mount "'is a mechanical fastener that connects two parts elastically.
• As a countermeasure, shock mounts can be installed to absorb resonant frequencies and thus dissipate the absorbed energy.
• A variety of accessories were available, including antennas, control heads, encryptors, head sets, shock mounts, speakers and interconnecting cables.
• The shock mounts were glued to the underside of the seat, and screwed in through the bottom of the chair.
• A similar idea, also known as a shock mount, is found in furniture design, introduced by Charles and Ray Eames.
• The soft shock mount grommets are just below the brass-colored screws at the four corners ( the left one is obscured ).
• Shock mounts for microphones can provide basic protection from damage, but their prime use is to isolate microphones from mechanically transmitted noise.
• The development of the automobile and the need for rubber shock mounts required stronger and more durable bonds of rubber and metal.
• The motor, itself, is the short gray cylinder just to the left of the most-distant shock mount; its shaft is parallel to the support rods.
• This design, along with the hidden shock mounts in the armrest allow the outside veneer of the chair to be unmarred by screws or bolts.
• The seat was joined to the spine and legs with a series of four heavy rubber washers with nuts embedded in them ( later these came to be called'shock mounts').
• The armrests are screwed to shock mounts which are connected only via glue to the interior of the backrest shell, allowing the backrest and headrest to flex when the chair is in use.